Recipe 18.8 Restricting What Log Messages Are Sent to the Server

18.8.1 Problem

You want to limit which logging levels the router will send to the syslog server.

18.8.2 Solution

Use the logging trap configuration command to limit the severity level of syslog messages:

Router#configure terminal
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#logging 172.25.1.1
Router(config)#logging trap notifications
Router(config)#end 
Router#

18.8.3 Discussion

By default, when you enable remote logging on a router, it will forward only those messages with a severity level of informational or higher (see Table 18-1). This means that the router forwards everything but debugging messages to the syslog server. Raising the severity of the log messages forwarded to the syslog server can help reduce bandwidth utilization across the network and minimize the disk space required for storing the log messages on the server. This example shows the output of the show logging EXEC command:

Router>show logging
Syslog logging: enabled (0 messages dropped, 0 messages rate-limited, 0 flushes, 0 
overruns)
    Console logging: level debugging, 658 messages logged
    Monitor logging: level debugging, 65 messages logged
    Buffer logging: level debugging, 6 messages logged
    Logging Exception size (4096 bytes)
    Trap logging: level notifications, 662 message lines logged
        Logging to 172.25.1.1, 5 message lines logged
        Logging to 172.25.1.3, 5 message lines logged
          
Log Buffer (4096 bytes): 
Router>

Note that the logging severity level is set to notifications, and that both outbound servers are limited to the same level. The logging trap command sets the severity level for all syslog servers.

Another important use for the logging trap command is to allow the router to send debug level messages to a syslog server. The default severity level for syslog is informational, so the router will not forward any debug messages. Having the ability to store debug messages can often be useful in fault isolation and trouble resolution. The following commands show how to enable the forwarding of debugging severity level messages:

Router#configure terminal
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#logging 172.25.1.1
Router(config)#logging trap debugging
Router(config)#end 
Router#

You must also configure the syslog server to handle debug level messages. You can accomplish this in one of two ways�by creating a dedicated file to handle debug messages, or by forwarding debug messages to the normal router log file. The following two examples will demonstrate how to modify your syslog.conf file to handle both situations:

local7.debug                          /var/log/debug

or:

local7.=debug                         /var/log/debug

The difference between these two methods is that while the first sends all messages with a severity greater than or equal to debug severity to the indicated file, the second directs only debug level messages to this file. The first example is a more traditional method used to assign debug level messages to a particular file, but the second example is preferred because it allows you to separate debug messages from the normal router log messages. Most modern syslog facilities will handle the second example command syntax, but check your manpages with the man syslog.conf command to ensure compatibility.

To simply forward all debug level messages to the default router log, change your syslog.conf files to include the following:

local7.debug                         /var/log/rtrlog

Use caution when enabling the remote storing of debug messages. Debug messages can quickly overwhelm your server if not properly enabled on the router.